Top

Clinical Oral Investigations

Published in:

01-06-2019 | Original Article

Effect of air-blowing time and long-term storage on bond strength of universal adhesives to dentin

Authors: Pipop Saikaew, Jiale Fu, A. F. M. Almas Chowdhury, Ricardo M. Carvalho, Hidehiko Sano

Published in: Clinical Oral Investigations | Issue 6/2019

Abstract

Objectives

To evaluate the effects of air-blowing time and storage time on microtensile bond strength (μTBS) of universal adhesives to dentin.

Materials and methods

Ninety flat dentin surfaces from extracted human third molars were bonded with three universal adhesives (Clearfil Universal Bond-CU; G-Premio Bond-GP; Scotchbond Universal Adhesives-SB). Bonded dentin surfaces were air-dried for 5 s, 15 s, or 30 s followed by resin composite built-up. Resin-dentin beams were tested with μTBS test after different storage time in distilled water (24 h and 1 year). Data were analyzed by three-way ANOVA and Duncan test at (α = 0.05). Failure mode and resin-dentin interfaces were observed using a scanning electron microscope (SEM). Specific features of fractured beams after μTBS were further observed using SEM at high magnification.

Results

Extension of air-blowing time from 5 s to 30 s increased the 24 h μTBS of CU only. Bond strength of all adhesives significantly decreased after 1-year storage except for CU at 5 s and 30 s of air-blowing time. One-year μTBS were significantly higher when air-blowing times were extended to 15 s for SB and 30 s for CU. Air-blowing time had no influence on GP.

Conclusion

The effect of air-blowing time and storage time on resin-dentin bond was material-dependent.

Clinical relevance

Extended air-blowing time increased the bond strength and bond durability of CU. Extension of air-blowing time to 15 s and 30 s improve the long-term bond strength of SB and CU, respectively.

Chen C, Niu LN, Xie H, Zhang ZY, Zhou LQ, Jiao K, Chen JH, Pashley DH, Tay FR (2015) Bonding of universal adhesives to dentine – old wine in new bottles? J Dent 43:525–536. https://doi.org/10.1016/j.jdent.2015.03.004 CrossRefPubMed

Wagner A, Wendler M, Petschelt A, Belli R, Lohbauer U (2014) Bonding performance of universal adhesives in different etching modes. J Dent 42:800–807. https://doi.org/10.1016/j.jdent.2014.04.012 CrossRefPubMed

Marchesi G, Frassetto A, Mazzoni A, Apolonio F, Diolosà M, Cadenaro M, di Lenarda R, Pashley DH, Tay F, Breschi L (2014) Adhesive performance of a multi-mode adhesive system: 1-year in vitro study. J Dent 42:603–612. https://doi.org/10.1016/j.jdent.2013.12.008 CrossRefPubMed

Chiba Y, Yamaguchi K, Miyazaki M, Tsubota K, Takamizawa T, Moore BK (2006) Effect of air-drying time of single-application self-etch adhesives on dentin bond strength. Oper Dent 31:233–239. https://doi.org/10.2341/05-19 CrossRefPubMed

Fu J, Pan F, Kakuda S, Sharanbir KS, Ikeda T, Nakaoki Y et al (2012) The effect of air-blowing duration on all-in-one systems. Dent Mater J 31:1075–1081CrossRefPubMed

Fu J, Saikaew P, Kawano S, Carvalho RM, Hannig M, Sano H, Selimovic D (2017) Effect of air-blowing duration on the bond strength of current one-step adhesives to dentin. Dent Mater 33:895–903. https://doi.org/10.1016/j.dental.2017.03.015 CrossRefPubMed

Spreafico D, Semeraro S, Mezzanzanica D, Re D, Gagliani M, Tanaka T, Sano H, Sidhu SK (2006) The effect of the air-blowing step on the technique sensitivity of four different adhesive systems. J Dent 34:237–244. https://doi.org/10.1016/j.jdent.2005.06.004 CrossRefPubMed

Moura SK, Murad CG, Reis A, Klein-Junior CA, Grande RH, Loguercio AD (2014) The influence of air temperature for solvent evaporation on bonding of self-etch adhesives to dentin. Eur J Dent 8:205–210. https://doi.org/10.4103/1305-7456.130602 CrossRefPubMedPubMedCentral

Sasakawa W, Nakaoki Y, Nagano F, Horiuchi S, Ikeda T, Tanaka T et al (2005) Micro-shear bond strength of five single-step adhesives to dentin. Dent Mater J 24:617–627CrossRefPubMed

10.

Inoue S, Vargas MA, Abe Y, Yoshida Y, Lambrechts P, Vanherle G, Sano H, van Meerbeek B (2001) Microtensile bond strength of eleven contemporary adhesives to dentin. J Adhes Dent 3:237–245PubMed

11.

Moszner N, Salz U, Zimmermann J (2005) Chemical aspects of self-etching enamel–dentin adhesives: a systematic review. Dent Mater 21:895–910. https://doi.org/10.1016/j.dental.2005.05.001 CrossRefPubMed

12.

Suppa P, Breschi L, Ruggeri A, Mazzotti G, Prati C, Chersoni S, di Lenarda R, Pashley DH, Tay FR (2005) Nanoleakage within the hybrid layer: a correlative FEISEM/TEM investigation. J Biomed Mater Res B Appl Biomater 73:7–14. https://doi.org/10.1002/jbm.b.30217 CrossRefPubMed

13.

Tay FR, Pashley DH, Yoshiyama M (2002) Two modes of nanoleakage expression in single-step adhesives. J Dent Res 81:472–476CrossRefPubMed

14.

Ikeda T, De Munck J, Shirai K, Hikita K, Inoue S, Sano H et al (2005) Effect of evaporation of primer components on ultimate tensile strengths of primer-adhesive mixture. Dent Mater 21:1051–1058. https://doi.org/10.1016/j.dental.2005.03.010 CrossRefPubMed

15.

Ikeda T, De Munck J, Shirai K, Hikita K, Inoue S, Sano H et al (2008) Effect of air-drying and solvent evaporation on the strength of HEMA-rich versus HEMA-free one-step adhesives. Dent Mater 24:1316–1323. https://doi.org/10.1016/j.dental.2008.02.009 CrossRefPubMed

16.

Saikaew P, Chowdhury AFMA, Fukuyama M, Kakuda S, Carvalho RM, Sano H (2016) The effect of dentine surface preparation and reduced application time of adhesive on bonding strength. J Dent 47:63–70. https://doi.org/10.1016/j.jdent.2016.02.001 CrossRefPubMed

17.

Yiu CKY, Pashley EL, Hiraishi N, King NM, Goracci C, Ferrari M, Carvalho RM, Pashley DH, Tay FR (2005) Solvent and water retention in dental adhesive blends after evaporation. Biomater 26:6863–6872. https://doi.org/10.1016/j.biomaterials.2005.05.011 CrossRef

18.

Armstrong S, Breschi L, Ozcan M, Pfefferkorn F, Ferrari M, Van Meerbeek B (2017) Academy of dental materials guidance on in vitro testing of dental composite bonding effectiveness to dentin/enamel using micro-tensile bond strength (muTBS) approach. Dent Mater 33:133–143. https://doi.org/10.1016/j.dental.2016.11.015 CrossRefPubMed

19.

Shono Y, Terashita M, Shimada J, Kozono Y, Carvalho RM, Russell CM, Pashley DH (1999) Durability of resin-dentin bonds. J Adhes Dent 1:211–218PubMed

20.

Feitosa VP, Leme AA, Sauro S, Correr-Sobrinho L, Watson TF, Sinhoreti MA, Correr AB (2012) Hydrolytic degradation of the resin–dentine interface induced by the simulated pulpal pressure, direct and indirect water ageing. J Dent 40:1134–1143. https://doi.org/10.1016/j.jdent.2012.09.011 CrossRefPubMed

21.

Pashley EL, Zhang Y, Lockwood PE, Rueggeberg FA, Pashley DH (1998) Effects of HEMA on water evaporation from water–HEMA mixtures. Dent Mater 14:6–10CrossRefPubMed

22.

Jacobsen T, Soderholm KJ (1995) Some effects of water on dentin bonding. Dent Mater 11:132–136. https://doi.org/10.1016/0109-5641(95)80048-4 CrossRefPubMed

23.

Giannini M, Arrais CA, Vermelho PM, Reis RS, dos Santos LP, Leite ER (2008) Effects of the solvent evaporation technique on the degree of conversion of one-bottle adhesive systems. Oper Dent 33:149–154. https://doi.org/10.2341/07-54 CrossRefPubMed

24.

Perdigao J, Sezinando A, Monteiro PC (2013) Effect of substrate age and adhesive composition on dentin bonding. Oper Dent 38:267–274. https://doi.org/10.2341/12-307-L CrossRefPubMed

25.

Thanatvarakorn O, Prasansuttiporn T, Takahashi M, Thittaweerat S, Foxton RM, Ichinose S, Tagami J, Nakajima M (2016) Effect of scrubbing technique with mild self-etching adhesives on dentin bond strengths and nanoleakage expression. J Adhes Dent 18:197–204. https://doi.org/10.3290/j.jad.a36033 CrossRefPubMed

26.

Van Meerbeek B, Yoshihara K, Yoshida Y, Mine A, De Munck J, Van Landuyt KL (2011) State of the art of self-etch adhesives. Dent Mater 27:17–28. https://doi.org/10.1016/j.dental.2010.10.023 CrossRefPubMed

27.

Frassetto A, Breschi L, Turco G, Marchesi G, Di Lenarda R, Tay FR et al (2016) Mechanisms of degradation of the hybrid layer in adhesive dentistry and therapeutic agents to improve bond durability–a literature review. Dent Mater 32:e41–e53. https://doi.org/10.1016/j.dental.2015.11.007 CrossRefPubMed

28.

Van Landuyt KL, De Munck J, Snauwaert J, Coutinho E, Poitevin A, Yoshida Y et al (2005) Monomer-solvent phase separation in one-step self-etch adhesives. J Dent Res 84:183–188. https://doi.org/10.1177/154405910508400214 CrossRefPubMed

Title: Effect of air-blowing time and long-term storage on bond strength of universal adhesives to dentin
Authors: Pipop Saikaew
Jiale Fu
A. F. M. Almas Chowdhury
Ricardo M. Carvalho
Hidehiko Sano
Publication date: 01-06-2019
Publisher: Springer Berlin Heidelberg
Published in: Clinical Oral Investigations / Issue 6/2019
Print ISSN: 1432-6981
Electronic ISSN: 1436-3771
DOI: https://doi.org/10.1007/s00784-018-2656-y

Keynote webinar | Spotlight on medication adherence

Springer Medicine

Effect of air-blowing time and long-term storage on bond strength of universal adhesives to dentin

Abstract

Objectives

Materials and methods

Results

Conclusion

Clinical relevance

Keynote webinar | Spotlight on medication adherence

Springer Medicine

Abstract

Objectives

Materials and methods

Results

Conclusion

Clinical relevance

Please log in to get access to this content

Other articles of this Issue 6/2019

Outcomes after up-front surgery and metronomic neoadjuvant chemotherapy with S-1 or UFT for early tongue squamous cell carcinoma

Effect of adjuvant use of metformin on periodontal treatment: a systematic review and meta-analysis

Efficacy of ultramicronized palmitoylethanolamide in burning mouth syndrome-affected patients: a preliminary randomized double-blind controlled trial

Effect of a structured plaque control on MMP-1 and MMP-9 crevicular levels in patients with desquamative gingivitis associated with oral lichen planus

Is composite repair suitable for anterior restorations? A long-term practice-based clinical study

Impact of cigarette smoking and vaping on the outcome of full-mouth ultrasonic scaling among patients with gingival inflammation: a prospective study